Just received your skates and they feel too small?
It is the most common concern when opening a figure skating package: you feel pressure and assume it is the wrong size. Take a deep breath—it is completely normal with technical boots. Learn how to check the fit before worrying.
The technical heel slide effect
Unlike a flat athletic sneaker, a figure skating boot features a raised heel designed to shift your center of gravity forward over the ball of your foot.
When you slide your foot into an unlaced boot, gravity pulls your entire foot forward, leaving an empty gap behind your heel and pushing your toes firmly against the stiff toe box.
Technical skates are not regular shoes: their rigid structure is engineered to hug your foot like a second skin to prevent injuries and transfer every push with surgical precision. Before requesting an exchange, follow this at-home testing protocol.
Pre-fitting setup
- Soft surface: Try them on over a clean carpet or towel. Zero scratches on the sole.
- Technical socks: Wear only thin skating socks used for training.
- Time of day: Try them on in the late afternoon, when your foot is at its natural volume.
Proper lacing
- Full opening: Loosen the laces all the way down and pull the tongue wide open.
- Heel tap: Gently tap your heel back into the carpet so it locks deep into the rear heel pocket.
- Progressive lacing: Snug yet smooth across the instep (one finger should fit under the crossover).
Dynamic fit test
- Skating stance: Bend your knees deeply forward as if skating (never judge standing upright).
- Toes and heel: Toes flat and lightly brushing the front; heel locked down without lifting.
- Side wrap: Firm hug around the forefoot with no sharp pain.
4. Official size and measurement reference chart
Use the extended guide below to verify the exact match between your actual foot length in centimeters, European sizes (EU), Mondopoint (MP), and approximate US equivalents:
5. Red lines: What NOT to do to preserve your exchange warranty
- Do not apply heat (hair dryers, heat guns, or ovens) until you are 100% certain of your size.
- Do not mount blades or wheel frames onto the boots, nor skate or roll on hard surfaces.
- Do not force the cuff with extreme repeated bending that creases the outer material.
- Keep packaging intact: Store the original box, tags, and protective inserts in pristine condition.
Still unsure after trying them on? Contact our technical support team at Stifeldshop with your exact foot measurements in millimeters and we will guide you personally.